Home > Att Uverse > At&t Wireless Box Not Working

At&t Wireless Box Not Working

Contents

Reply Jenny says: October 23, 2012 at 6:33 am So I ran across this site, but this article doesn't addess my issue. what do I do to get rid of this?? I would appreciate any suggestions, June Reply Brenden says: November 23, 2014 at 11:02 am I have Uverse with a tower and a WAP. Checkfor Interference Make sure there are no devices around the Wireless Access Point or Wireless Receiver that can cause interference, such as cordless phones, baby monitors, etc... check over here

I have been paying for high speed internet service, the most expensive one they offer and i am only getting slow service, which kicks me off at least 20 times a Hello Jarange, I can also help you resolve the issues you are experiencing. I hope this helps. What gives? https://forums.att.com/t5/Watching-U-verse-TV/Wireless-receiver-loses-connection-to-access-point/td-p/3611937

Att Uverse Tv Is Not Available At This Time

We Have Advice! Have you found a solution? When I had Dish and their signal went out, they told me I could watch prerecorded programs stored on my Dish dvr??? I replied to the e-mail that you sent ot me but I still have had no response and AT&T does not show an order for this.

Comcast Xfinity vs Verizon Fios: A Thorough Comparison AT&T U-verse vs. The new WAP does not use the 5GHz band that the Cisco WAP used. I am having this exact problem.Both of my wireless receiverslose the Cisco WAP signal. At&t U Verse Tv Is Not Available At This Time Restart Receiver link.

Take a minute to learn more about what AT&T Wi-Fi has to offer! Uverse Wireless Box Won't Connect Plug the power back into the U-verse router first, and then plug the power into the Cisco WAP after the U-verse router comes up. After two minutes, the Link light on the front of the Wireless TV Receiver should be solid green. Please reply as quickly as possible because I am still having the problems.

The tv worked for about an hour and then it stopped working, saying there was no signal. Att Uverse Reset Receiver Message The i tried turning off the receiver for 10 minutes. Your distance from the distribution box, probably a large grey freestanding box slightly bigger than a phone booth somewhere in your neighborhood, determines how many streams you can have. We Have Advice!” Hy Chea says: September 30, 2010 at 5:17 pm I check around and found out all of my friends has different cable provider that able to view the

Uverse Wireless Box Won't Connect

Is there a way to confirm the firmware version and update it, or does anyone have any other suggestions. I have a wireless att uverse receiver in our bedroom. Att Uverse Tv Is Not Available At This Time September 16, 2014 Jessica Sims U-verse Problems? Att Uverse Not Available At This Time Restart Receiver I will be sending you a private message to discuss this further.

What would cause this? check my blog One of the receivers is less than 20 feet away from the WAP.I have an ethernet connection to a local switch, that the WAP plugs into. You need to find abetter location for the WAP by trial and error. This will help other forum members locate it and will also let everyone know that it corrected your problem. Att Uverse Troubleshooting No Signal

We always prefer a direct connection to our U-verse router due to the Quality of Service control it offers. I have more than 240 series we have identified to record, and none of them show up on my "scheduled to record" screen. I remember sometime back there was a firmware upgrade that was supposed to fix this, which I believe I got. this content I don't know your specific setup but it seems like the WAP may need to be relocated.

Disconnect the DVR All the receivers in the house have to pair with the DVR through for DVR content. Http //www.att.com/wireless Tv All other marks are the property of their respective owners. It just started happening after we got uverse.

Any advice?

The computers show a signal that goes in and out. I have the Cisco AP. Access help on your TV. Att Uverse Tv Is Not Available At This Time Restart Receiver I can help you determine if it needs to be replaced.

This week suddenly the range went from 50 feet to 2. Help!!! When I got the uverse a few months back I wanted everything hard wired because I did not believe this would work. have a peek at these guys Select OK to review and read your recent messages.

We have the gray modem set up in the kitchen, in an open space. Yep, this day in age and they can't figure out how to give us multiple lines to watch TV. Tried reset several times also. It's not dangerously hot, but it's hot.

Additionally, the same thing occurs when we use our tread mill i.e., both audio and video become corrupted. I would be willing to try that. The new receiver worked for about 10 minutes before it no longer would respond to the remote. Reply marlon says: June 24, 2014 at 7:43 am I had a problem with the connection in one of my rooms and they sent someone out to fix it but now

Reply Corene says: July 27, 2012 at 10:47 pm I just "upgraded" my phone, internet, and tv to uverse 2 weeks ago. How do i get to a point that I can watch TV or Recordings? I greatly apologize for everything once again, and if you have replied back by private message, please disregard my comment. -David T If you encounter any issues with your service For details, visit www.ctia.org.This link will open a new window link.

It is a direct connection with no switches , etc between the two.Open to suggestions. It won't allow the other TV's to view HD at the same time.